|
|
|
|
|
|
|||||||
| The Pub For General Automotive Related Talk |
 |
|
|
Thread Tools | Display Modes |
29-01-2015, 03:59 PM
|
#1 | ||
|
Regular Member
Join Date: Jun 2006
Location: S.E melbourne
Posts: 211
|
Hey Guys,
Sorry if this is in the wrong spot but I'm trying to locate a fabricator (SE suburbs or inner east of Melbourne) that deals with welding Aluminium? I haven't been lazy i have searched everywhere but every time i find recommendations for good fabricators their contact details are virtually non-existent? Anyone that works from home or does after-hours/weekend drop offs would be a bonus too. The work i need done is as follows: i have a raptor supercharger kit on my Au xr8 and the BOV flange on my intake pipe has never been angled correctly to line up with the plumb back pipe just before the mouth of the supercharger. i also need a better method for holding my air temp sensor in position as it blows out under boost (current method is a rubber grommet holding it in there..... and cable ties) Appreciate any help guys, Cheers |
||
|
|
|
30-01-2015, 11:53 PM
|
#2 | ||
|
trying to get a leg over
 
Join Date: Dec 2004
Location: Melbourne
Posts: 2,690
|
With out a doubt these guys are the best I've ever seen.
http://www.trikfab.com.au/Default.htm
__________________
Cameron ------------------------------------------------------ |
||
|
|
|
|
05-02-2015, 08:24 AM
|
#3 | ||
|
Regular Member
Join Date: Oct 2010
Location: Perth
Posts: 391
|
My brother is a very good fabricator and lives in Nunawading. If you're still looking for someone send me a PM and I'll send you his number.
|
||
|
|
|
Aluminium Fabricators SE Melb!?
Linear Mode
