|
|
|
|
|
|
Welcome to the Australian Ford Forums forum. You are currently viewing our boards as a guest which gives you limited access to view most discussions and inserts advertising. By joining our free community you will have access to post topics, communicate privately with other members, respond to polls, upload content and access many other special features without post based advertising banners. Registration is simple and absolutely free so please, join our community today! If you have any problems with the registration process or your account login, please contact us. Please Note: All new registrations go through a manual approval queue to keep spammers out. This is checked twice each day so there will be a delay before your registration is activated. |
|
|||||||
|
|
Thread Tools | Display Modes |
27-12-2018, 08:26 PM
|
#1 | ||
|
FF.Com.Au Hardcore
Join Date: Jun 2005
Location: Brisbane
Posts: 1,029
|
Had a ticking noise coming from the top of the motor, assumed it to be a bad lifter. Pulled the inlet manifold off, took off the rockers and found the pushrod on one of the rockers was stuck to it and sitting further in than the others. Problem found. Had a spare set of YT rockers, so using them and replace all the old ones.Since I have new lifters I thought I might as well put them in. Problem is I can't fit the first and last ones in. Noticed the original ones are tapered at the bottom but the new ones are not.
Any way these can be fitted or do I have to take off the heads.
__________________
We salute those brave souls that enter the DARK side |
||
|
|
Fitting new lifters in windsor with heads on
Threaded Mode